Comtech EF Data DT-4500 Series - Firmware:) Select; UTILITY:) AID (Application Identification String) Submenu

DT-4500 Series C- and Ku-Band Down Converters MN/DT4500.IOM
Front Panel Operation Revision 2
6–25
(FIRMWARE:) INFOIMAGE#1/#2APP
App#X: FW-0000203x
X.X.X MM/DD/YY
(FIRMWARE:) INFOIMAGE#1/#2FPGA
FPGA#X: FW-0000204
X.X.X MM/DD/YY
6.2.7.3.2 (FIRMWARE:) SELECT
Current Active Image: #1
Next Reboot Image: #1 #2
Use this submenu to select the Current Active Firmware Image.
The read-only top line shows the Current Active Image. On the bottom line, use
the   keys to select #1 or #2 as the Next Reboot Image (i.e., the image that
will be active the next time the unit is rebooted). Press ENTER.
If the image that you select is already set as the designated Next Reboot Image,
this message displays:
THAT IMAGE IS ALREADY
CURRENT. NO CHANGE MADE.
You may repeat the task by instead selecting the alternate image.
6.2.7.4 (UTILITY:) AID (Application Identification String) Submenu
Edit AID Message?
No Yes
The Application Identification (AID) submenu allows you to create a customized
message. The AID may serve to identify the satellite, either transponder, beam,