DT-4500 Series C- and Ku-Band Down Converters MN/DT4500.IOM
Firmware Update Revision 2
5–15
2. Verify the new firmware version has booted; for example, check the
firmware version displayed on the DT-4500 front panel:
DT_45XX –X
SW VER X.X.X SN#########
5.4.4.2.2 Soft-reboot the Unit from the HTTP Interface
Do these steps from the HTTP Interface ‘Config | Utility’ page:
1. In the ‘Perform Soft Reboot’ section, click [Reboot Now]:
2. Wait while the DT-4500 reboots with the Current Active Firmware Image.
3. To load a second image, repeat the tasks described throughout Section
5.4.4.
The DT-4500 is now operating with its latest firmware. The firmware update
process is complete.
To Next Page
Loading...
