Comtech EF Data DT-4500 Series - Use the DT-4500 Front Panel to Get the Management IP Address and Firmware Information; Use the HTTP Interface to Find the Firmware Information

DT-4500 Series C- and Ku-Band Down Converters MN/DT4500.IOM
Firmware Update Revision 2
5–4
5.2.3.1 Use the DT-4500 Front Panel to Get the Management IP
Address and Firmware information
Chapter 6. FRONT PANEL OPERATION
Using the unit front panel:
• You may view find the factory-assigned Management IP Address within
the CONFIG  REMOTE ETHERNET  ADDRESS menu branch:
IP Address/Range:
XXX.XXX.XXX.XXX/YY
• You may view the current Firmware M&C version at the top-level menu
of the front panel display (press the [CLEAR] key several times):
DT_45XX –X
SW VER X.X.X SN#########
• You may view the detailed firmware information within the UTILITY 
FIRMWARE INFO  IMAGE#1 or IMAGE#2  BULK menu branches:
Image#X: BULK APP FPGA
Bulk#X: FW-0000202x
X.X.X. MM/DD/YY
5.2.3.2 Use the HTTP Interface to Find the Firmware Information
Chapter 7. ETHERNET INTERFACE OPERATION
Do these steps:
1. Go to either of these pages to review the firmware information:
• The ‘Firmware Information’ section of the ‘Config | Utility’ page
provides the firmware details as Boot, Bulk1, and Bulk2, as shown
in this example: