DT-4500 Series C- and Ku-Band Down Converters MN/DT4500.IOM
Serial Interface Operation Revision 2
8–13
8.7.2.6 MAC (Media Access Control Address)
Use MAC to return the unique MAC address of the rear panel ‘Ethernet’ M&C
port.
>DEV/MAC_xx-xx-xx-xx-xx-xx{cr}{lf}] where:
xx=MAC address byte in hexadecimal
8.7.2.7 IPA (IP Address)
Use IPA to set or return the Management IP Address and network prefix for the
rear panel ‘Ethernet’ M&C port. The factory default value is 192.168.1.4.24.
<DEV/IPA_aaa.bbb.ccc.ddd.yy{cr} where:
aaa = 0 to 223*
bbb = 0 to 255*
ccc = 0 to 255*
ddd = 0 to 255*
*Values cannot all be zeroes.
yy = Subnet Mask Length (8 to 30)
>DEV/IPA_ aaa.bbb.ccc.ddd.yy{cr}{lf}]
>DEV/IPA_ aaa.bbb.ccc.ddd.yy{cr}{lf}]
8.7.2.8 IPG (IP Gateway)
Use IPG to set or return the IP Gateway Address for the rear panel ‘Ethernet'
M&C port. The factory default value is 192.168.1.5.
<DEV/IPG_aaa.bbb.ccc.ddd{cr} where:
aaa = 0 to 223*
bbb = 0 to 255*
ccc = 0 to 255*
ddd = 0 to 255*
*Values cannot all be zeroes.
>DEV/IPG_ aaa.bbb.ccc.ddd{cr}{lf}]
>DEV/IPG_ aaa.bbb.ccc.ddd{cr}{lf}]