DT-4500 Series C- and Ku-Band Down Converters MN/DT4500.IOM / CD-MNDT4500
Table of Contents Revision 2
xvi
Figure 7-4. HTTP Interface “Splash” Page Example ............................................ 7–8
Figure 7-5. HTTP Interface Menu Tree (FW Ver. 1.3.4) ....................................... 7–9
Figure 7-6. ‘Home | Home’ Page ...................................................................... 7–11
Figure 7-7. ‘Home | Contact’ Page .................................................................... 7–12
Figure 7-8. ‘Home | Support’ Page ................................................................... 7–13
Figure 7-9. ‘Admin | Access’ Page ..................................................................... 7–14
Figure 7-10. ‘Admin | SNMP’ Page .................................................................... 7–16
Figure 7-11. ‘Config | Converter’ Page ............................................................. 7–17
Figure 7-12. ‘Config | Ref’ Page ........................................................................ 7–19
Figure 7-13. ‘Config | Pre-selects’ Page ............................................................ 7–20
Figure 7-14. ‘Config | Utility’ Page .................................................................... 7–21
Figure 7-15. ‘Config | Redundancy’ Page .......................................................... 7–23
Figure 7-16. ‘Status | Summary’ Page .............................................................. 7–24
Figure 7-17. ‘Status | Faults’ Page .................................................................... 7–25
Figure A-1. 1:1 Redundant Configuration –Single Source IF Output (with IOM and
RSM) ............................................................................................................. A–4
Figure A-2. 1:1 Redundant Configuration Diagram – Single Source IF Output (with
IOM and RSM) .............................................................................................. A–4
Figure A-3. 1:1 Redundant Configuration Diagram – Single Source RF Input (with
IOM and EQM) ............................................................................................. A–5
Figure A-4. EQM Panel – Connector Locations ................................................... A–5
Figure A-5. 1:1 Redundant Configuration – Dual Source IF Output ................... A–5
Figure A-6. 1:1 Redundant Configuration Diagram – Dual Source IF Output (with
IOM and RSM) .............................................................................................. A–6
Figure A-7. Dual Source 1:N Redundant Configuration (with PSM and RSM) .... A–7
Figure A-8. Dual Source 1:N Redundant Configuration Diagram (with PSM and
RSM) ............................................................................................................. A–8
Figure A-9. Front Panel Example – 1:3 System Configuration ............................ A–9
Figure A-10. Front Panel Example – System in AUTO Redundancy Mode ....... A–10
Figure A-11. Front Panel Example – Down Converter #01 Backup .................. A–11
Figure A-12. Front Panel Example – Down Converter #01=MAN, Others=AUTO
................................................................................................................... A–12
Figure A-13. Front Panel Example – Down Converter #01 Forced Backup ...... A–13
Figure A-14. ‘Config | Redundancy’ Page ......................................................... A–14
Figure B-1. DT-4500 Signal and Interconnecting Diagram – 1:N Redundancy
“Inline” Unit Example (with RSM)................................................................ B–1
Figure B-2. DT-4500 Front Panel (DT-4503 Shown) ............................................ B–2
Figure B-3. “Personality” Module Examples ....................................................... B–5
To Next Page
Loading...
