Configuration and Setup 3-4
Follow the instructions on your screen.
See the section “Running the Scanner Maintenance Program” for detailed instructions.
9
Set localization Preferences
On the iJET Panel - Select Menu > Advanced > Options >… to set preferences for language,
paper series and media handling (loading).
See the section about options for ”Personalizing and localizing the system” for details.
10
Make Printer Setup settings on the scanner
You can setup for two printer types – a B&W printer and a color printer. After you setup your
printers, pressing the Color Copy button will send the output to your color printer and pressing
the B&W Copy button will send the output to your B&W printer.
On the iJET Panel
Printer set up is described for Color Printer below. The same rules and method applies for B&W
Printer setup.
Select Menu > Advanced > Printer Setup > Color Printer to make settings.
Select Menu > Advanced > Printer Setup > Color Printer > Interface > USB if you used a USB
connection between the scanner and the printer and LAN if you used a LAN connection. If you
selected LAN, use the arrow up/down buttons to enter the printer’s IP address.
Select the Printer Model setup method – Auto Configure, Printer List or Custom Setup and apply
the additional setting(s) attached to the Printer Model setup method you selected.
See the section “Printer Setup on the Scanner” for more details.
11
Prepare the Printer
Perform actions and settings on the printer device such as check that the right paper is loaded
and the printer is ON. See your printer’s documentation for help.
12
Create a system media type for your printers media (Closed Loop Calibration)
For the color printer only - You must create a system media type profile in order to color match
paper media, printer and scanner before using the system. Identify the media type (Coated,
Glossy, Semi-Glossy) you use with the printer and then perform closed loop calibration (3 steps).
On the iJET Panel
Select Menu > Advanced > Options > Closed Loop Cal.
Press Enter and then use the arrows up/down buttons to reach the right media type and Enter to
select. With some printers you will also need to perform the Calibrate Rip step.
On “Print Sheet” select Enter. The system will print a color patch sheet.
Feed the sheet into the scanner
On “Scan Sheet” select Enter. The system will scan the color patch sheet and calculate color
matching values for future jobs with the current media type.
See the section on “how do I… Create a New Media” for more details.
13
Test your system
Make a simple copy to test your system.
See the section on “how do I… Make a Copy” for details.
To Next Page
Loading...
