Contex FLEX50i - Page 57

Using the scanner, how do I … Copy? 5-5
5.2.3 How do I…Set Copy Quality?
You can determine the output quality. The best quality will take the longest to output and use the highest
amount of ink on inkjets. You may want to use the Fast quality setting for test copies. Yo can set Quality
to one of its three options: Fast, Normal, Best.
You can see which of the quality settings is active by the LEDs above the Quality button. The active
setting will be the only one that is lighted. In the example below the Best setting is active.
You can press the Quality button until the LED for the Quality setting you want to use lights up.
Fast Normal Best
Quality
To set the copy Quality value:
On the iJET Panel –
1. Quick - Press the Quality button. The iJET Panel display will open the Quality option with
the “>” marker on the value level indicating you can immediately change the Quality option’s value.
From here you can skip steps 2 and 3 and go to step 4 to change the value.
2. Menu – Press the button to enter the main Menu.
Use the arrow up/down buttons to move through the Menu options until the display shows
Quality.
3. Press
Enter
to move the “>” marker down to indicate you want to change the Quality value.
4. There are two ways to change the value:
5. Repeated presses to the Quality button will change the Quality value forward through Fast,
Normal, Best. The list wraps around meaning that you step from Best to Fast when you continue to
press the button.
The LEDs above the Quality button will show the active setting.
6. Or…press the arrow up/down buttons to change the Lightness value. With these you
can step both forward and backward in the Fast, Normal, Best quality list.
Menu
Fast Normal Best
Fast Normal Best
Quality
Quality
> Fast
Quality
Quality
>Normal
Quality
Quality
> Best
Quality
> Normal
Quality
The “>” marker is down to the value level so you can
change the value.
Quality
> Normal
> Quality
Normal