Using the scanner, how do I … Copy? 5-6
7. Press the
button to accept the selected value. The “>” marker will move up to the Menu
level indicating that the value is set and you can step on through the menu options if needed. The
new Quality value will be applied every time you press the B&W Copy or Color Copy button until you
repeat the steps above to change it.
5.2.4 How do I… Set number of Copies?
You can tell the system to make multiple copies of the original in the scanner. You can set the system to
output between 1 and 50 copies. The default value is 1.
To set the copy Copies value:
On the iJET Panel –
1. Quick Button Setting - Press the Copies button The iJET Panel display will open the
Copies option with the “>” marker on the value level indicating you can immediately change the
Copies option’s value. From here you can skip steps 2 and 3 and go to step 4 to change the value.
2. Through the Menu – Press the button to enter the main Menu.
Use the arrow up/down buttons
to move through the Menu options until the display shows
Copies.
3. Press
to move the “>” marker down to indicate you want to change the Copies value.
4. There are two ways to change the value:
5. Repeated presses to the Copies button will change the Copies value forward in single steps from 1
to 50..
6. Or…press the arrow up/down buttons
to change the Copies value. With these you can
increase and decrease the value.
7. Press the
button to accept the selected value. The “>” marker will move up to the Menu level
indicating that the value is set and you can step on through the menu options if needed. The new
Copies value will be applied every time you press the B&W Copy or Color Copy button until you
repeat the steps above to change it.
The ”>” marker is on the Menu level
navigating the menu options with the arrow up/down
The “>” marker is down to the value level so you can
Copies
> 1
> Copies
1
The ”>” marker is on the Menu level
navigating the menu options with the arrow up/down
To Next Page
Loading...
