Crestron Zum - Page 108

108 • Crestron Zūm® Wired Solutions Product Manual — Doc. 9349B
3. Wire the device as shown below. Additional LINE, NEUT, and GND connections are
supplied for power pass-through. When making connections, consider the following:
l
Wires should be 24 to 10AWG.
l
Strip wires to 5/16in. (8mm).
l
Tighten screw terminals to 4.5in.-lbs (0.5Nm).
4. Connect the orange CBL-CAT5E-ZUMLINK-P (sold separately) to the ZUMLINK ports.