44 • Crestron Zūm® Wired Solutions Product Manual — Doc. 9349B
Load Controller Specifications
Zūm Wired load controllers include:
l
ZUMNET-JBOX-16A-LV Product Specifications on page 44
l
ZUMNET-JBOX-DALI Specifications on page 46
l
ZUMLINK-JBOX-16A-LV Specifications on page 49
l
ZUMLINK-JBOX-20A-PLUG Specifications on page 52
l
ZUMLINK-JBOX-20A-SW Specifications on page 55
l
ZUMLINK-EXP-16A-DIMU Specifications on page 58
ZUMNET-JBOX-16A-LV Product Specifications
Load Control
Dim Load Types 0-10V LED drivers or electronic ballasts (4-wire)
Switch Load Types LED, electronic ballasts, incandescent, magnetic low-voltage, electronic low-
voltage,neon/cold cathode, high-intensity discharge, small motor loads
Load Rating 16A 100-277VAC, 50/60 Hz;
0.5 HP @ 120-277VAC
Dim Control Output 0-10VDC, 60mA maximum sink or source
Short Circuit Protection 40A non-replaceable fuse
Power Requirements
Line Voltage 100-277VAC, 50/60 Hz
Wired Communications
ZUMNET (LAN) (2) RJ-45 ports;
Input for control system connection or Zūm Net device;
Output for Zūm Net device daisy-chaining
ZUMLINK (ROOM) (2) RJ-45 ports;
In-room Zūm Link device daisy-chaining;
85mA power available for Zūm Link devices, including ZUMLINK-KP keypads
24V, OCC, GND Occupancy sensor input;
85mA available output current;
Spring clamp connector
24V, PHO, GND Photo sensor input;
Spring clamp connector
OVR, GND Override control input;
Spring clamp connector
To Next Page
Loading...
