Product Manual — Doc. 9349B Crestron Zūm® Wired Solutions • 119
Remove or Attach the Backplate
To remove the backplate from the presence detector:
1. Locate the two sliding tabs on opposite sides of the presence detector.
2. Extend the sliding tabs out of the housing. A flat-head screwdriver can be used.
Once both sliding tabs are exposed, the presence detector releases from the backplate.
To attach the backplate to the presence detector:
1. Ensure the sliding tabs are extended out of the housing.
2. Align the pins on the back of the presence detector with the socket on the backplate and
press.
3. Push both sliding tabs back into the housing
Junction Box Mounting
The presence detectors are compatible with 4 in. square junction boxes, 4 in. round junction
boxes, and 3 in. mud rings (not included). After the junction box is installed, follow the procedure
for mounting the presence detectors.
To Next Page
Loading...
