Product Manual — Doc. 9349B Crestron Zūm® Wired Solutions • 107
Wiring the Universal Dimmer Load Controller
WARNING: RISK OF SERIOUS PERSONAL INJURY. To avoid fire, shock, or death, turn off
the power at the circuit breaker(s) or fuse and test that power is off before installing and
wiring! Installing with power on can result in serious personal injury and damage to the
device.
1. Insert the included bushing into the knockout hole to protect the low voltage wires.
2. Use a #2 Phillips screwdriver to remove the cover screws and then remove the cover.
To Next Page
Loading...
