34 • Crestron Zūm® Wired Solutions Product Manual — Doc. 9349B
ZUML-HUB4-CN-PAK
l
Facilitates quick setup of a centrally managed Zūm light control system
l
Convenient preassembled lighting control cabinet
l
Contains a ZUM-HUB4 Zūm hub, PW-2420RU power pack, DIN-EN-6X18 wall mount
enclosure, DIN-AP4 control processor, two CEN-SW-POE-5 switches, two DIN-HUB
Cresnet hubs, and two DIN-PWS60 power supplies for the DIN-HUB
For additional details and specifications, refer to the ZUM-HUB4 information in this guide and
the PW-2420RU, DIN-AP4, DIN-HUB, DIN-PWS60, CEN-SW-POE-5, and DIN-EN-6X18 product
pages.
1. SIMPL+® software modules are provided for use in commissioning a Crestron control system to work with the
ZUM-HUB4. The software modules run within the control system program and provide virtual connections for all
the necessary intersystem control signals. A separate dedicated module is required for each external and
mirrored room. Control systems are limited in the number of modules supported, ranging from 0 to 2001000
depending on the model. For further assistance, please contact Crestron Commercial Lighting Support via email
at clclighting@crestron.com or by calling 855-644-7643.
2. Other Crestron control systems must be commissioned to provide the control logic required to communicate and
operate as part of the Zūm network. Once integrated, each external room effectively becomes a part of the Zūm
ecosystem.
To Next Page
Loading...
