Next we can choose a path for Mach3 program and decide if software should be installed for all users.
Mostly we just leave the default settings and then double-click „Next”.
Name selection in start menu - mostly there is no need to change anything here also - click „Next” and
again „Next” when you see a summary review.
After this lasting few seconds setup another window will show up - with question if you want to launch
CSMIO/IP controller firmware that serves to controller updates. If you are not sure if you have the latest
version, you can update it now. Update process was described in B Addition.
If you do not want to update now deselect the „Launch CSMIO/IP-A Controller Firmware” option and click
„Finish”.
CS- Lab s.c. – CSMIO/IP- A - CNC controller
Page 52
To Next Page
Loading...
