1.2 Content
The CSMIO/IP-A device is placed in a cartoon box with DB->Terminal Block adapters for easier wires con-
nection in a control cabinet. More content details below:
• CSMIO/IP-A - CNC controller
• 3x DB25Terminal block (2 pcs.)
• Ethernet connection wire
• DB25 connection tape (6 pcs.)
• „Phoenix” 3pin power plug
• CD with electronic version of the user guide and software
(always check if there is a newer version on
http://www.cs-lab.eu )
In case of lack of any elements listed above, please contact your distributor.
CS- Lab s.c. – CSMIO/IP- A - CNC controller
Page 7
To Next Page
Loading...
