EasyManua.ls Logo

D-Link NetDefendOS - Page 190

D-Link NetDefendOS
912 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Default: 128
Ringsize_yukon_rx
Size of Yukon receive ring (per interface).
Default: 256
Ringsize_yukon_tx
Size of Yukon send ring (per interface).
Default: 256
Ringsize_yukonii_rx
Size of Yukon-II receive ring (per interface).
Default: 256
Ringsize_yukonii_tx
Size of Yukon-II send ring (per interface).
Default: 256
Interface Monitor Settings
Below, is a list of the monitor settings that are available for NetDefendOS Ethernet interfaces.
IfaceMon_e1000
Enable interface monitor for e1000 interfaces.
Default: Enabled
IfaceMon_BelowCPULoad
Temporarily disable ifacemon if CPU load goes above this percentage.
Default: 80
IfaceMon_BelowIfaceLoad
Temporarily disable ifacemon on and interface if network load on the interface goes above this
percentage.
Default: 70
IfaceMon_ErrorTime
How long a problem must persist before an interface is reset.
Chapter 3: Fundamentals
190

Table of Contents

Related product manuals