rule to be triggered.
Metric Specifies an interval that the metric of the routers needs to be in
between.
Router ID Specifies if the rule should filter on Router ID.
OSPF Route Type Specifies if the rule should filter on the OSPF Router Type.
OSPF Tag Specifies an interval that the tag of the routers needs to be in between.
4.6.4.3. OSPF Action
This object defines an OSPF action.
General Parameters
Export to Process Specifies into which OSPF AS the route change should be imported.
Forward If needed, specifies the IP to route via.
Tag Specifies a tag for this route. This tag can be used in other routers for
filtering.
Route Type Specifies what the kind of external route type. Specify 1 if OSPF
should regard external routes as type 1 OSPF routes. Type 2 is the most
significant cost of a route.
OffsetMetric Increases the metric of an imported route by this value.
Limit Metric To Limits the metrics for these routes to a minimum and maximum value.
If a route has a higher or lower value than specified then it will be set
to the specified value.
4.6.4.4. Routing Action
A Routing Action is used to manipulate and export routing changes to one or more local routing
tables.
Destination Specifies into which routing table the route changes to the
OSPF AS should be imported.
Offset Metric Increases the metric by this value.
Offset Metric Type 2 Increases the Type 2 router's metric by this value.
Limit Metric To Limits the metrics for these routes to a minimum and
maximum value. If a route has a higher value than specified
then it will be set to the specified value.
Static Route Override Allows the override of the static routes.
Default Route Override Allows the override of the default route.
4.6.5. Setting Up OSPF
Chapter 4: Routing
348
To Next Page
Loading...
