The system will validate and start using the new configuration. When the command prompt is
shown again:
gw-world:/> commit
The new configuration is now committed.
Web Interface
1. Go to: Configuration > Save and Activate in the menu bar
2. Click OK to confirm
The web browser will automatically try to connect back to the Web Interface after 10 seconds. If
the connection succeeds, this is interpreted by NetDefendOS as confirmation that remote
management is still working. The new configuration is then automatically committed.
Note: Changes must be committed
The configuration must be committed before changes are saved. All changes to a
configuration can be ignored simply by not committing a changed configuration.
Chapter 2: Management and Maintenance
77
To Next Page
Loading...
