To Next Page

To Previous Page

6-7

FUEL SYSTEM

ASSEMBLY

● Install the needle jet, needle jet holder, main jet and

slow jet.

● Tighten the pilot jet until it seat lightly, then turn it out

as much as number recorded during removal.

● Install the pilot jet rubber.

● Install the float valve set, float comp, float pin.

● Measure the float level with the float valve gauge.

FLOAT LEVEL : 13 mm

TOOL : FLOAT COMP LEVEL GAUGE

● Install the float chamber set.

● Install the stay plate set and 4 pan screws.

● Install the valve plate set, compression spring in the

vacuum piston comp.

● Install the diaphragm cover with its cutout aligned with

the cover.

● Place the top set on the spring.

● Tighten the 2 special pan screws.

SCREW SET

FLOAT CHAMBER SET

TOP SET

Be sure to replace the float chamber body O-ring

with the new one.

NOTE

Install the jet needle aligned with the grooves.

NOTE

DAELIM B-BONE Service Manual

Other manuals for DAELIM B-BONE