User's Manual
23
Table 4-6 General function description
Icons Name Description
ANPR Receive
Select the check box, and the Camera automatically receives
vehicle snapshots, and detects event information triggered
by sources such as radar or video detection, and displays such
snapshots, and information at the lower part of the page.
The snapshots are saved in the storage path defined by
Setting
>
Storage
>
Destination
>
Save Path
.
Record Type Select the format of video recordings (
dav
by default).
Talk
Click
Talk
, and you can communicate with people on site
through the camera.
Manual
Snapshot
Click to take a snapshot when a vehicle passes. The snapshot
is saved in the storage path.
●
Enable
ANPR Receive
first.
●
To change the storage path of snapshots, go to
Setting
>
Storage
>
Destination
>
Save Path
.
Digital Zoom
Drag to select any area in the video window, and then the
area will be zoomed in. In any area of the video window, click
or right-click to exit.
Video
Recording
Click it to start recording. Click again to stop recording.
You can set the storage path of video recordings from
Setting
>
Storage
>
Destination
>
Save Path
.
Config (LPR)
You can draw the area of plate detection, adjust camera’s
focal length, and set applicable region.
Click .
Figure 4-22 Config (LPR)