User's Manual
42
Table 4-18 Barrier control parameter description
Parameter Description
Barrier Always Open
Select it, and enable the function of barrier always open. Configure
the period of barrier always open. The barrier will not close during the
defined period.
On Select it to enable barrier control, and configuration.
Barrier Opening Control
Triggers alarm through different modes, and remotely controls the
barrier opening and close.
●
Every Trigger (Camera)
: Capture any vehicle, and output open
barrier signal.
●
Every Plate (Camera)
: Capture any plated vehicle, and output
open barrier signal.
●
Allowlist Open (Camera)
: Capture the vehicle which conforms to
allowlist or fuzzy matching, and then output open barrier signal.
●
Order (Server)
: Platform sends command, and output open
barrier signal.
You can configure barrier opening control as
Allowlist Open
(Camera)
, and
Order (Server)
at the same time.
Allowlist Open
(Camera)
takes priority.
Barrier Opening Config ●
Relay-out
: Alarm linkage output port. You can select anyone one
of the 3 ports.
●
Signal Duration
: The duration that the barrier opening or closing
signal lasts.
Barrier Closing Config
Step 3 Click
Confirm
.
4.5.1.6 RS-485
You can configure the RS-485 serial protocol of the external device. After configuration, you can set
related parameters of the device on Web.
Step 1 Select
Setting
>
ITC
>
RS-485
>
Trigger Mode
.
Step 2 Configure parameters.
1) DHRS.
Figure 4-48 DHRS parameters
To Next Page
Loading...
Need help?
General
