User's Manual
38
4.5.1.4.2 Face Overlap
In this section, you can select whether to overlap the face image of the driver and assistant driver
onto the snapshot, and the overlap position and size.
Step 1 Select
Setting
>
ITC
>
Cutout
>
Face Overlap
.
Step 2 Configure the parameters as needed.
Figure 4-41 Face overlap
Step 3 Click
Confirm
.
4.5.1.5 Blocklist and Allowlist
4.5.1.5.1 Fuzzy Matching
Enable fuzzy match, and set the fuzzy match conditions. The vehicle with plate meeting the
matching conditions will be considered as allowlist vehicle, and the Camera will automatically open
the barrier.
Step 1 Select
Setting
>
ITC
>
Blocklist and Allowlist
>
Fuzzy Matching
.
Figure 4-42 Fuzzy matching
Step 2 Select the
Enable
check box to enable fuzzy match, and then configure the parameters as
needed.