User's Manual
39
Table 4-17 Allowlist parameters description
Parameter Description
Lost 1 Character at The Ends
Plate number will be matched when the first or last character of
the detected plate is missing.
Redundant 1 Character at
the Ends
Plate number will be matched when one more character is
detected before the first character or after the last character of
the plate.
Tolerant Matching
(Character)
Set the tolerant matching value (
0
,
1
, or
2
), and plate number
will be matched successfully when 0, 1, or 2 characters different
from the recorded plate number are detected.
Equivalent matching
Characters
Click to add the fuzzy match condition. For example, if o is
detected by the Camera, the character will be automatically
recognized as 0, as shown in the figure above.
Step 3 Click
Confirm
.
4.5.1.5.2 Allowlist
You can search, and check whether a plate number is included in the allowlist, or you can import or
export plate number in the allowlist.
Step 1 Select
Setting
>
ITC
>
Blocklist and Allowlist
>
Allowlist
.
Figure 4-43 Allowlist
Step 2 Configure parameters.
●
Plate No.: Enter the plate number (enter some characters). Click
Search
, and check
whether the plate number exists in the allowlist.
●
Edit plate information: Click of the corresponding plate number searched, and edit
the plate number.
●
Delete single plate number: Click of the corresponding plate number searched, and
delete it from the allowlist.
●
Delete plate number in batches: click
Clear All
, and then click
Confirm
in the dialog
box to delete all the allowlist information.
●
Adding vehicles to allowlist one by one:
1) Click
Add
.
To Next Page
Loading...
Need help?
General
