Figure 5-67
Step 2 Check the box to enable this function, input IP address and port. Refer to the
following sheet for detailed information.
The multicast IP address (0.0.0.0～255.255.255.255).
The multicast port value(1025～65000).
Step 3 Click Save to complete the setup.
Step 4 Login and monitor.
Use WEB to login, you can see the following interface. See Figure 5-68. Select
login type as the Multicast from the dropdown list. After you logged in the Web,
the Web can automatically get multiple cast address and add it to the multiple
cast groups. You can enable real-time monitor function to view the video.
Figure 5-68
5.7.2.12 Auto Register
This function allows the device to auto register to the proxy you specified. In this way, you
can use the client-end to access the DVR and etc via the proxy. Here the proxy has a
switch function. In the network service, device supports the server address of IPv4 or
domain.
Step 1 From main window->Setup->Network->Register.
Enter register interface is shown as below. See Figure 5-69.
To Next Page
Loading...
