It is to set flow statistic mode and alarm activation items.
Step 1 From main menu->Setup->Event->People counting.
Enter people counting interface shown as in Figure 5-93.
Step 2 Select a channel from the dropdown list and then check the box to enable people
counting function. Click Save.
Step 3 Click Draw rule to draw the rule. Left click mouse to draw a line, until you draw a
rectangle, you can right click mouse.
Figure 5-93
Step 4 Set parameters. Refer to chapter 5.7.3.1.1 motion detect for detailed information.
Check the box to enable people counting function, and then select people
counting detection channel.
Check the box here; you can view the people amount on the surveillance
video.
It is to set people flow direction. It includes entry/exit.
It is to set people entry amount. System can generate an alarm once the
amount has exceeded the threshold.
It is to set people entry amount. System can generate an alarm once the
amount has exceeded the threshold.
It is to set people staying amount in the zone. System can generate an alarm
once the amount has exceeded the threshold.
To Next Page
Loading...
