Check the box to enable NTP function.
Set the time server address.
Check the NTP box to enable this function.
Host IP: Input the server IP that installed the NTP server.
Manual update: Click it, you can sync DVR time with the NTP server
manually.
Port: System supports TCP transmission only. The port value is 123.
Interval: It is to set the sync time interval between the DVR and the NTP
server. The value ranges from 0 to 65535 minutes.
It is to set the time server port.
It is to set the sync periods between the device and the time server.
Step 3 Click Save to complete the setup.
5.7.5.1.3 Holiday Setup
Step 1 From main menu->Setup->System->General->Holiday.
Enter Holiday interface. See Figure 5-133.
Figure 5-133
Step 2 Click Add holidays.
Enter add holiday interface. It is to set holiday name, repeat mode and start
time/end time. See Figure 5-134.
To Next Page
Loading...
