Local Configurations 23
Network configuration Figure 4-6
Configure the settings for the network parameters. For details, see Table 4-1. Step 2
Table 4-1 Network Settings
In the IP Version list, you can select IPv4 or IPv6. Both versions are supported for
access.
For IPv6 version, in the IP address box, Gateway box, Preferred DNS box, and
Alternate DNS box, enter 128 bits and cannot be blank.
According to your network plan, enter the modified IP address, gateway, and subnet
mask.
IP address and gateway must be in the same network segment.
Select the DHCP box, the Device automatically obtains an IP address. In this case,
you do not need to set the IP address, gateway, and subnet mask.
If DHCP is effective, the obtained value will display in the IP Address box,
Subnet Mask box and Gateway box. If DHCP is not effective, 0 will be
displayed.
To view the current IP address, if DHCP is not effective, you can disable DHCP
to display the IP address information that is not obtained by DHCP; if DHCP is
effective, disabling DHCH will not display the previous IP information, then you
need to reconfigure the IP address parameters.
TCP service port. The default setting is 37777.
User Datagram Protocol. The default value setting is 37778. You can enter the value
according to your actual situation.
Hyper Text Transfer Protocol port. The default setting is 80. You can enter the value
according to your actual situation, and in this case, please add the modified value
after the address when logging the Device on the browser.
To Next Page
Loading...
Need help?
General