Design Guide | iC2-Micro Frequency Converters Approvals and Certifications
2 Approvals and Certifications
2.1 Product Approvals and Certifications
iC2-Micro Frequency Converters comply with the required standards and directives. For detailed information on which approvals and
certifications a product has, see the product type label and http://www.danfoss.com.
Certificates and Declarations of Conformity are available on request or at https://www.danfoss.com/en/service-and-support/
documentation/.
Table 3: Approvals and Certifications Applicable to Drives
Approval Description
The drive complies with relevant directives and their related standards for the extended Single Market in the Euro-
pean Economic Area.
For more information, see Table 4.
The Underwriters Laboratory (UL) mark indicates the safety of products and their environmental claims based on
standardized testing. The drive complies with UL 61800-5-1. For UL file number, see the product label.
UL approval CCN LZGH2/8 which covers flame arrest-protected components for use in refrigeration and air-condi-
tioning equipment employing A2L refrigerants, which are constructed so that, under normal or expected abnor-
mal end-product operating conditions.
The CSA/cUL approval is for drives of voltage rated at 600 V or lower. Compliance with the relevant UL/CSA stan-
dard makes sure that safety design together with relevant information and markings, ensures that when the drive
is installed and maintained according to the provided operating or installation guide, the equipment meets the UL
standards for electrical and thermal safety. This mark shows that the product complies with all required engineer-
ing specifications and testing. A certificate of compliance is provided on request.
The drive complies with relevant regulation and their related standards for Great Britain.
UKCA contact information:
Danfoss, 22 Wycombe End, HP9 1NB, Great Britain
The RCM Mark label indicates compliance with the applicable technical standards for Electromagnetic Compatibil-
ity (EMC). An RCM Mark label is required for placing electrical and electronic devices on the market in Australia and
New Zealand. The RCM Mark regulatory arrangements only deal with conducted and radiated emission. For drives,
the emission limits specified in EN/IEC 61800-3 apply. A declaration of conformity can be provided on request.
The drive complies with relevant directives and their related standards for the Morocco market. Download the
French product guides from .
The Korea Certification (KC) Mark indicates that the product conforms to relevant Korean standards.
Danfoss A/S © 2024.08 AJ402315027937en-000401 / 130R1239 | 13
To Next Page
Loading...
