Marking Area Specification
User Manual 23
F-Theta Scan Lens for Arex™ 130-X6X and 150-X6X
The table below lists the standard F-Theta scan lenses currently available for
Arex™ 130-X6X and 150-X6X:
F-Theta Scan Lens diameter: M85
F-Theta Scan Lens 160L 254L 330L
Working Distance mm 176 ± 2 296 ± 5 388 ± 6
Fixing Distance mm 212 ± 3 367 ± 6
471 ± 7
Marking Area mm 100 x 100 170 x 170 210 x 210
NOTE
NOTE
WD: Working Distance
FD: Fixing Distance
MA: Marking Area
AB: Aiming Beam
FB: Focusing Beam
NOTE
For products equipped with 160S, 254S, 160L and 100L F-Theta scan lenses the focus
position, defined at the point where the focus beam overlaps with the aiming beam, is
preset at factory.
Fixing Distance is defined as the distance be
tween the base of the scan head and the
marking area. Refer to the following figure.
Working Distance is defined as the distance between the center of the marking area
(defined in t
he focal plane) and the closest mechanical edge of the F-Theta scan lens.
Refer to the following figure.
To Next Page
Loading...