Datalogic Arex 400 - Timing Diagrams; Turning on Sequence; Marking Control Signals Behavior

Timing Diagrams
User Manual 37
Timing Diagrams
Turning On sequence
typ 60s
user
defined
within
50ms
user
defined
within
50ms
Figure 18: Turning On sequence timing diagram
Marking control signals behavior
T1
T2
T3
T4
T5
T6
Figure 19: Marking process timing diagram
REF. NAME
DESCRIPTION
T1 Start Time
Minimum time duration that the START_MARKING signal must
have in order to be accepted as a valid START_MARKING event
T2 Start Delay
Delay between the acceptance of the START_MARKING signal and
the rising edge of the
BUSY signal
T3 Busy Advance
Delay between the rising edge of the BUSY signal and the laser
emission
T4 Stop Time
Minimum time duration that the STOP_MARKING signal must have
in order to be accepted as a valid STOP_MARKING event
T5 Busy Delay
Delay between the end of the laser emission and the falling edge of
the
BUSY signal
T6 End Time Time duration of the END signal
NOTE
Consult Lighter™ software user's manual for a proper use of the same.