Datalogic Arex 400 - Green Spot

Technical Specifications
24 Arex™ 400
Green Spot
The Green Spot is an indicator integrated in the scan head able to provide a
green visual feedback in the center of marking field area.
Figure 3: Green Spot indicator
CONFIGURATION
1
1. refer to Lighter™ user's manual “Setting I/O parameters” paragraph to set the signal properties
OFF The Green Spot indicator is not active (always OFF)
SYSTEM READY TO MARK
The Green Spot is steady ON only when all these events are verified:
- the laser marker is in READY state
- a document is in AUTO MODE or WORK MODE
- the marking process is not in progress
MARKING CONFIRMATION
The Green Spot turns ON when all these events are verified:
- the laser marker is in READY state
- a document is in AUTO MODE or WORK MODE
- the marking process was correctly executed (no errors, no
st
op marking, no state changing)
The Green Spot indicator turns ON at the end of the marking process and
stay active for a configurable range of time from 0.1s to 5s
MARVIS VERIFICATION
This is available only if MARVIS™ feature is enabled.
The Green Spot turns ON when all these events are verified:
- the laser marker is in READY state
- a document is in AUTO MODE or WORK MODE
- the marking process was correctly executed (no errors, no
st
op marking, no state changing)
- the verification of the marking content made by MARVIS™
dev
ice was positive
The Green Spot indicator turns ON at the end of the marking process and
stay active for a configurable range of time from 0.1s to 5s
DESCRIPTION