First time boot
User Manual 51
Before turning on the laser marker, be sure that the laser marker is connected as
previously described. Check the presence of:
•Voltage power supply connection
• Safety Circuit connection
• Command Box connection
W
ARNING
W
ARNING
W
ARNING
If the Command Box Muting Device provided is connected, the laser marker enable is
bypassed.
It is the customer's responsibility to provide a correct integration of the safety signals
according to applic
able regulations.
Do not use the Safety Circuit Muting Device for
external devices, since this will result in
loss of the safety function of the machine to which this product is installed.
Do not use the Safety Circuit Muting Device except for maintenance oh this product.
First time boot
NOTE
W
ARNING
W
ARNING
DO NOT turn OFF or UNPLUG the laser marker while Windows® is shutting down.
Wait for the shutdown of the operating system.
The first time the laser marker is turned on after it
has been unpacked, it warns that
the operating system will be restarted within a few seconds.
To Next Page
Loading...