Accessories
68
Arex™ 400
I/O interface
Dedicated to on-site quick and easy termination, PLC interfacing, System Test, I/
O troubleshooting, etc. The DB25 Pass-through Command Box connector allows
the integrator to use the interface as a I/O test tool on previously installed prod-
ucts.
• I/O Monitoring LED lamps
• Easy assembly thanks to screw down termination
• Dry contact outputs
•Dry contact inputs
• DIN rail mounting enclosure
Figure 3: I/O interface (ordering no: 985330032)
NOTE
Refer to I/O Interface instruction manual for more information.
DB25-to-Free Leads Cable
This accessory allows an easier integration of the laser marker: the Command
Box connector signals are all available on the free leads side of the cable, labeled
with cable tags.
Figure 4: DB25-to-free leads cable (ordering no. 985350032)
To Next Page
Loading...