Use and operation
52
Arex™ 400
Turning On sequence
The laser marker states can be controlled by:
• Key Selector
• Command Box connector
Sequence using Key Selector
W
ARNING
Controlling the laser marker states using the Key Selector on the control rack front
panel requires that the input signals of the command box connector
EXT_KEY
,
EXT_ENABLE_A
and
EXT_ENABLE_B
are set to fixed HIGH level.
Turn ON the main power supply switch in the back panel of the control rack. The
laser marker turn on and goes in booting-up state:
Figure 1
:
Power on the laser marker
During booting up state, the status LED on the control rack and the status LED
on the scan head blink green.
Wait until booting-up finish: the status LED on the control rack and the status
LED on
the scan head are steady green. The laser marker is in WAIT FOR START
state.
Figure 2: Wait for start state
To Next Page
Loading...