Datalogic MAGELLAN 3200VSI - Datamatrix Length 1, Length 2 Programming Instructions

Enter/Exit Programming Mode Datamatrix
132 Magellan™ 3200VSI
Datamatrix Length 1, Length 2 Programming Instructions
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the Set Length 1 or Set Length 2 bar code.
3. Turn to Appendix C, and scan the four digits (zero-padded) representing
the length.
NOTE
For Datamatrix bar codes, only the data ch
aracters are included in the
length calculations.
Any value set higher than 800 wil
l be considered to be 800.
Complete the programming sequence by scanning the Enter/Exit Programming
Mode bar code.
DEFAULT SETTING FOR THIS FEATURE: 0001
Set Length 1
Set Length 2
DEFAULT SETTING FOR THIS FEATURE: 0800