RS-232 Interface Features Enter/Exit Programming Mode
Product Reference Guide
55
Retry on ACK NAK Timeout
Enables/disables retry after the configurable ACK NAK Timeout Value (set in the
following feature) has expired.
Disable Retry on ACK NAK Timeout
Enable Retry on ACK NAK Timeout
DEFAULT
ACK NAK Timeout Value
This item specifies the time the scanner will wait for an ACK character from the host following a label transmission.
00 = Infinite timeout
01 - 75 = Timeout in 200-millisecond increments
To configure this feature, scan the “Enter/Exit Programming Mode” bar code above to place the unit in Programming
Mode, then the “Set ACK NAK Timeout Value,” followed by the two digits (zero padded) from the Alphanumeric table in
Appendix C,
representing your desired value. Exit programming mode by again scanning the “Enter/Exit Program-
ming Mode” bar code above.
DEFAULT SETTING FOR THIS FEATURE: 01 (200 msec)
Set ACK NAK Timeout Value
To Next Page
Loading...
