Product Reference Guide 179
Appendix H
microSD Card
microSDHC Compatibility
At the time of this writing, the microSD card interface for this product supports
SD-Memory Card Specifications/ Part 1. Physical Layer Specification; Version
1.01, but the processor MCI can communicate with SDHC Cards. For example,
the scanner can perform the functions specified in this appendix for the SDA
2.0 specification. Both FAT16 and FAT32 formats are supported.
Filenames are limited to the 8.3 file naming format (i.e., FILENAME.EXT), and
MUST be capitalized.
microSD Card Insertion
1. Read all of these instruc-
tions before starting.
Back Cover
Optional Back
Cover/Stand
Assembly
2. If you have not already done
so, remove the scanner from
its installed position to
allow access to the microSD
card slot.
3. Separate the scanner from
i
ts back cover.
4. Ensure there are no other
ca
bles attached to the scan-
ner, then apply power and wa
it for the reset beep.
5. Lift and rotate the rubber
co
ver to access the card
slot, then carefully insert
the microSD card into the
slot until it "clicks" into
place.
Scanner
microSD Card
Push down past
ush to seat,
then carefully
release
Seated card
To Next Page
Loading...
