Enter/Exit Programming Mode
70 Magellan™ 3200VSI
Wedge Quiet Interval
NOTE
This feature does not apply to the
USB Keyboard interface.
Quiet Interval is the amount of time to look for keyboard activity before the
scanner breaks the keyboard connection in order to transmit data to the host.
Selectable from 001 to 100 in 10 msec increments. To configure this feature, scan the “Enter/Exit Programming Mode”
bar code above to place the unit in Programming Mode, then the
Set Wedge Quiet Interval
bar code followed by
the three digits (zero padded) from the Alphanumeric table in
Appendix C,
representing your desired length. Exit
programming mode by again scanning the “Enter/E
xit Programming Mode” bar code above.
DEFAULT SETTING FOR THIS FEATURE:
010 (100 msec)
Set Wedge Quiet Interval
To Next Page
Loading...
