Enter/Exit Programming Mode
26 Magellan™ 3200VSI
ERI Timeout
Specifies the amount of time the External Read Indicator (ERI) signal is held
active for a good read.
Sets the ERI timeout duration using hex values from 000 to 255 in increments of ten milliseconds (10ms or 0.01 sec-
onds). To configure this feature, scan the “Enter/Exit Programming Mode
” bar code above to place the unit in Pro-
gramming Mode, then the “Set ERI Timeout,” followed by the t
wo digits (zero padded) from the Alphanumeric table in
Appendix C,
representing the desired time value. Exit programming mode by scanning the “Enter/Exit Program-
ming Mode” bar code again.
DEFAULT SETTING FOR THIS FEATURE: 20 milliseconds (02)
Set ERI Timeout
To Next Page
Loading...
