Enter/Exit Programming Mode Maxicode
138 Magellan™ 3200VSI
Maxicode Length 1, Length 2 Programming Instructions
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the Set Length 1 or Set Length 2 bar code.
3. Turn to Appendix C, and scan the four digits (zero-padded) representing
the length.
NOTE
For Maxicode labels, only the data characters are included in the length
ca
lculations.
Any value set higher than 138 will be considered to be 138.
Complete the programming sequence by scanning the Enter/Exit Programming
Mode bar code.
DEFAULT SETTING FOR THIS FEATURE: 0001
Set Length 1
Set Length 2
DEFAULT SETTING FOR THIS FEATURE: 0138
To Next Page
Loading...
