Enter/Exit Programming Mode
54 Magellan™ 3200VSI
ACK Character
Sets the ACK character from the set of ASCII characters or any decimal value from 000 to 255. Pad entries of less than
three digits with zeros, as in “005”. To configure this feature, scan the “Enter/Exit Programming Mode” bar code above
to place the unit in Programming Mode, then the “Set ACK Character,” followed by the digits from the Alphanumeric
table in
Appendix C,
representing your desired character. Exit programming mode by again scanning the “Enter/
Exit Programming Mode” bar code above.
DEFAULT SETTING FOR THIS FEATURE: 006
Set ACK Character
NAK Character
Sets the NAK character from the set of ASCII characters or any decimal value from 000 to 255. Pad entries of less than
three digits with zeros, as in “005”. To configure this feature, scan the “Enter/Exit Programming Mode” bar code above
to place the unit in Programming Mode, then the “Set NAK Character,” followed by the digits from the Alphanumeric
table in
Appendix C,
representing your desired character. Exit programming mode by again scanning the “Enter/
Exit Programming Mode” bar code above.
DEFAULT SETTING FOR THIS FEATURE: 021
Set NAK Character
To Next Page
Loading...
