Enter/Exit Programming Mode Global Prefix/Suffix
74 Magellan™ 3200VSI
Global Prefix/Suffix
Up to 20 ASCII characters may be added as a prefix (in a position before the bar
code data) and/or as a suffix (in a position following the bar code data).
Sets up to 20 characters each from the set of ASCII characters or any hex value from 00 to FF. To configure this fea-
ture, scan the “Enter/Exit Programming Mode” bar code above
to place the unit in Programming Mode, then the “Set
Prefix” or “Set Suffix,” followed by the digits from the Alphanumeric table in
Appendix C,
representing your
desired character(s). Reference the section,
"Example: Setting a Prefix"
on page 145, for more information. Exit
programming mode by scanning the “Enter/
Exit Programming Mode” bar code again (scan “Enter/Exit Programming
Mode” twice if less than 20 characters have been selected).
DEFAULT SETTING PREFIX: 00 (None)
DEFAULT SETTING SUFFIX: 0D (CR)
Set Prefix
Set Suffix
To Next Page
Loading...
