Datalogic MAGELLAN 3200VSI - ACK NAK Error Handling; ACK NAK Retry Count

Enter/Exit Programming Mode
56 Magellan™ 3200VSI
ACK NAK Retry Count
This feature sets the number of times for the scanner to retry a label transmission under a retry condition. 
000 = No retry 
001 - 254 = Retry for the specified number of times 
255 = Retry forever 
To configure this feature, scan the “Enter/Exit Programming Mode” bar code above to place the unit in Programming
Mode, then the “Set ACK NAK Retry Count,” followed by the three digits (zero padded) from the Alphanumeric table in
Appendix C, representing your desired retry count. Exit programming mode by again scanning the “Enter/Exit Pro-
gramming Mode” bar code above
DEFAULT SETTING FOR THIS FEATURE: 003
Set ACK NAK Timeout Value
ACK NAK Error Handling
This item specifies the method the scanner will use to handle errors detected
while waiting to receive the ACK character from the host. Errors include unrec-
ognized host commands and
communication errors such as parity or framing
errors. Choices are:
00 = Ignore errors detected (recommended setting)
01 = Process error as valid ACK character (risk of lost label data)
02 = Process error as valid NAK character (risk of duplicate label data)
Ignore Errors Detected
DEFAULT
Process error as valid ACK character
Process error as valid NAK character