NOTE
DEFAULT SETTING FOR THIS FEATURE: mP
(6D500000 hex)
Set Micro PDF 417 Label ID Character(s)
Set QR Code Label ID Character(s)
DEFAULT SETTING FOR THIS FEATURE: QR (51520000
hex)
DEFAULT SETTING FOR THIS FEATURE: MC (4D430000
hex)
Set Maxicode Label ID Character(s)
Set Aztec Label ID Character(s)
DEFAULT SETTING FOR THIS FEATURE: Az (417A0000
hex)
DEFAULT SETTING FOR THIS FEATURE: R4 (52340000
hex)
Set GS1 DataBar Omnidirectional 2D Composite
Label ID Character(s)
Set GS1 DataBar Limited 2D Composite
Label
ID Character(s)
DEFAULT SETTING FOR THIS FEATURE: RL (524C0000
hex)
DEFAULT SETTING FOR THIS FEATURE: RX (52340000
hex)
Set GS1 DataBar Expanded 2D Composite
Label ID Character(s)
For the 2D symbologies on this page, the Label ID is 4 bytes. The first 3 bytes are
characters for the label ID. A 00 (hex) value in the first 3 bytes indicates the end of the
label ID characters. The 4th byte is a control byte.
The use of the control byte is as follows:
bit 0-if set to 1, the AIM ID is appended for that label type
Label ID Enter/Exit Programming Mode
Product Reference Guide
81
To Next Page
Loading...
