Datalogic PowerScan PD9531-AR - China Sensible Code Set Length 2

Enter/Exit Programming Mode 2D Global Features
184 PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
China Sensible Code Set Length 2
This feature specifies one of the bar code lengths for China Sensible Code
Length Control. Length 2 is the maximum label length if in Variable Length
Mode, or the second fixed l
ength if in Fixed Length Mode. Characters can be
set from 0001 to 7,827 characters in increments of 0001 (pad with zeroes).
See page 290 for detailed instructions on setting this feature.
Select China Sensible Code Length 2 Setting
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
Appendix D, Keypad repre-
senting your desired character(s). End by scanning
the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL
bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
Length 2 is 7,827 Characters