Datalogic PowerScan PD9531-AR - Master Header;Terminator (Prefix;Suffix)

Enter/Exit Programming Mode
246 PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
RS-485 Master Header/Terminator (Prefix/Suffix)
Specifies the Master Cradle header or terminator characters to be added to a
label sent to Host. The characters may be added as a prefix (in a position
before the bar code data, also called a header) and/or as a suffix (in a posi-
tion following the bar code dat
a, also called a terminator).
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE bar
code above to place the unit in Programming Mode, then the “Set Master
Cradle Prefix” or “Set Master Cradle Suffix” bar code followed by the digits
(in hex) from the Alphanumeric characters in Appendix D, Keypad repre-
senting your desired character(s). If less
than the expected string of 8 char-
acters are selected,
scan the ENTER/EXIT bar code to terminate the string.
Exit programming mode by scanning the ENTER/EXIT bar code again.
Set Master Cradle Prefix
Set Master Cradle Suffix
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL