Datalogic PowerScan PD9531-AR User Manual

Enter/Exit Programming Mode
Product Reference Guide 263
Set String ID
Sets the identifier of the predefined strings.
Set String ID
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by 6 digits from the Alphanu-
meric characters in
Appendix D, Keypad .
The ID characters must be represented by their
hex
adecimal ASCII code; if the first 2 digits are 0, this
feature is disabled. End by scanning the ENTER/EXIT
bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not
save the entry string. You can then start
again at the beginning.
CANCEL
Set String Header
Sets the header of the predefined strings.
Set String Header
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by 32 digits from the Alphanu-
meric characters in
Appendix D, Keypad .
The digits must be the hexadecimal ASCII represen-
tation of the desired characters. If less than the
ex
pected string of 16 characters are selected, scan
the ENTER/EXIT bar code to terminate the string.
If the first 2 digits are 0, the feature is disabled. End
by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not
save the entry string. You can then start
again at the beginning.
CANCEL

Datalogic PowerScan PD9531-AR Specifications

General

Brand	Datalogic
Model	PowerScan PD9531-AR
Category	Barcode Reader
Language	English