Enter/Exit Programming Mode
240
PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
Radio Sleep
Disables the radio when the scanner is in standby mode in order to save the
battery power. When Radio sleep is enabled, the scanner cannot receive
asynchronous messages nor paging button requests from the base. The
scanner is still able to receive ACK From Host message. See "STAR Radio
Transmit Mode" on
page 239.
Radio Sleep = Sleep Disable
Radio Sleep = Sleep Enable
Changing System Speed
1. Link the PM9501-AR with a BC9xxx Base.
2. With the PM9501-AR, read a “Comp
atible Mode/Normal Mode Speed”
programming label on page 243 to set “Low, Medium, or High Speed”.
3. Place the PM9501-AR into the BC9xxx.
The Reader and Base will now be linked at the new programmed speed.
This feature can also be programmed using Datalogic Aladdin.
1. On the BC9xxx Base, change the Compa
tible mode parameter to low,
intermediate, or high speed through Aladdin.
2. Place an unlinked PM9501-AR onto the BC9xxx base.
The Reader and base will link at
the new programmed speed.