Datalogic PowerScan PD9531-AR User Manual

Enter/Exit Programming Mode
264 PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
Set String Terminator
Sets the terminator of the predefined strings.
Set String Terminator
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by 32 digits from the Alphanu-
meric characters in
Appendix D, Keypad.
The digits must be the hexadecimal ASCII represen-
tation of the desired characters. If less than the
e
xpected string of 16 characters are selected, scan
the ENTER/EXIT bar code to terminate the string.
If the first 2 digits are 0, the feature is disabled. End
by scanning the ENTE
R/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
an
d not save the entry string. You can then start
again at the beginning.
CANCEL

Datalogic PowerScan PD9531-AR Specifications

General

Brand	Datalogic
Model	PowerScan PD9531-AR
Category	Barcode Reader
Language	English