Datalogic PowerScan PD9531-AR - Barcode;Key Different Data Format; Set F4 Label

Enter/Exit Programming Mode
274 PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
Set F4 Label
This item allows the user to change the default mnemonic label associated
to each individual function key. This is done by programming a short acro-
nym 4-character string to be shown in the bottom of the display. The pur-
pose of the label is to serve as an indication of the programmed function of
th
e Function Key below it.
Set F4 label
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by 8 digits from the
Appendix
D, Keypad
. The digits must be the hexadecimal
ASCII representation of the desired characters.
End by scanning the ENTER/EXIT bar code again.
Barcode/Key Different Data Format
If this parameter is enabled, barcode and keyboard entered data can be for-
matted separately. More specifically: if this parameter is disabled, barcode
and keyboard data will share the same He
ader and Terminator defined using
“Set Barcode Header” and “Set Barcode Terminator” below. If this parameter
is enabled, keyboard entered data are treated differently, as their format
must be programmed through the parameters "Set String Header", "Set
String Terminator", "Set Key Sequence Header" and "Set Key Sequence Ter-
minator".
Disable
DEFAULT
Enable